Kaiba UN-E05 Nippers for Optical Molding Support Material, 4.7 inches (120 mm)

Specialty tool for removing support materials produced by 3D printers in photo-format Dedicated tool for cutting and removing support materials generated by 3D printers in photo-format You can effectively remove support materials that require repetitive detail work. The small and delicate blade can be easily inserted into the entry area. The handle can be held while holding the handle so you can work without obstructing your view. The handle has a flat surface and is polished to make it easy to hold your fingers. Comes with spring for good workability. Winner of the Good Design Award. Made in Japan

• Uses: Cutting and removing support materials produced by optical modeling methods 3D printers
• Material: SUS420J2, Hardness: HRC48-53, Blade Length: 0.4 inches (9 mm)
• Compatible Wires: UV hardening resin, Cutting Capacity: Less than 0.04 inch (1 mm) of resin for optical modeling 3D printers
• Do not cut any wire other than the above materials. This may cause breakage such as cracking and chipping
• This is a non-insulated tool. Please do not work while going through electricity